Polaris 2012 RANGER RZR 570 INTL Service Manual page 242

CLUTCHING
Troubleshooting, Continued.....
Situation
-Plugged air intake or outlet.

-Belt slippage due to water, oil, grease, etc.,
rubbing on cover.
PVT cover
-Clutches or weight being applied to cover
overheating
while in operation.
(melting)

-High vs. low range.
-Cover seals or ducts leaking

Water ingestion -Operator error
-Belt worn out

Belt slippage -Water ingestion

-Belt contaminated with oil or grease
-Belt worn or separated, thin spots, loose belt
PVT noise
-Broken or worn clutch components, cover
hitting clutches
-Thin spots on belt, worn belt
Engagement
erratic or stabby
-Drive clutch bushings stick
6.26
Probable Cause
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.
Remedy
-Clear obstruction

-Inspect system. Clean , repair or replace as
necessary. 
Seal PVT system ducts.
-Remove weight. Inform operator.


-Instruct operator on guidelines for operation in
proper driving range for different terrain as ou tlined
in Owner's Safety and Maintenance Manual.
-Find leak and repair as necessary.

-Instruct operator on gu idelines for operation in wet
terrain as outlined in Owner's Safety and
Maintenance Manual.
-Replace belt.

-Inspect and seal PVT system.

-Inspect and clean.
-Replace belt.

-Inspect and repair as necessary.
-Replace belt. Refer to belt burnt troubleshooting
and instruct operator.
-Inspect and repair clutches.