Special Tools; Torque Specifications; Wheel And Hub Torque Table; Front Bearing Carrier - Polaris 2012 RANGER RZR 570 INTL Service Manual

FINAL DRIVE

SPECIAL TOOLS

PART NUMBER
2872608
8700226
PU-48951
SPX Tools: 1-800-328-6657 or http://polaris.spx.com/.

TORQUE SPECIFICATIONS

Wheel and Hub Torque Table

ITEM
Steel Wheel Nuts
Aluminum Wheel Nuts
(INTL)
Front Hub Castle Nut
Rear Hub Castle Nut
7.2
TOOL DESCRIPTION
Roll Pin Removal Tool
CV Boot Clamp Pliers
(earless type)
Axle Boot Clamp Tool
SPECIFICATION
27 ft. lbs. (37 Nm)
30 ft. lbs. (41 Nm)
+ 90° (1/4 turn)
80 ft. lbs. (108 Nm)
80 ft. lbs. (108 Nm)
9923523 - 2012 RANGER RZR 570 Service Manual
© Copyright 2011 Polaris Sales Inc.

FRONT BEARING CARRIER

Bearing Carrier Inspection / Removal

1. Elevate front of vehicle and safely support machine
under the frame area.
Serious injury may result if machine tips or falls.
Be sure machine is secure before beginning this
service procedure. Wear eye protection when
removing bearings and seals.
2. Check bearings for side play by grasping the top and
bottom of the tire firmly and checking for movement.
The tire should rotate smo othly witho ut b inding or
rough spots.
3. Remove the (4) wheel nu ts an d re move the front
wheel.
4. Remove the cotter pin and loosen the front wheel hub
castle nu t. Re move th e nut, and (2 ) cone washers
from the front wheel hub assembly.
Castle Nut
Cone
Washers
5. Remove the fastener retaining the steering tie rod end
to the front bearing carrier.
CAUTION
Cotter Pin