Audio Tones - Fuji Xerox ApeosPort-IV C7780 Administrator's Manual

5 Tools
If you select [Adjust by Month, Day & Time], specify the month, day, and time for [Start Date]
and [End Date].
If you select [Adjust by Month, Week, Day of Week & Time], specify the month, week, day of
week, and time for [Start Date] and [End Date].
Print-On-Demand Duration (ApeosPort Series Models Only)
Specify the duration for the machine to receive a print job from web applications. Unless the
machine receives full data of the print job within the specified period of time, the machine
does not process the print job.
Specify the time duration between 0 and 255 minutes in 1 minute increments. If you specify
[0], it means that there is no time limit set on the machine for receiving data.
Note

Audio Tones

Select whether to sound an alarm when a job ends or a fault occurs.
Control Panel Select Tone
Set the volume to be sounded when a button on the control panel is correctly selected.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
5
Control Panel Alert Tone
Set the volume to be sounded when a button that cannot be selected is selected, or an error
occurs.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Base Tone
Set the volume for the base tone of the toggle button, which changes setting each time it is
pressed. The machine plays this sound when it exits the Interrupt mode.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Machine Ready Tone
Set the volume to be sounded when the machine is ready to copy or print, or powered on.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Job Complete Tone 1, 2
Set the volume to be sounded when a job is completed normally.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
You can select the target jobs to play the sound.
Fault Tone
Set the volume to be sounded when a job fails.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
You can select the target jobs to play the sound.
Auto Clear Alert Tone
Set the volume to be sounded at five seconds before automatically returning to the initial
screen when [Auto Clear] is set to [On].
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
For information on Auto Clear, refer to "Auto Clear" (P.150).
152
• When you send a print job that contains a large amount of data or a print job whose contents
take a while to be processed, transmission may be timed out before the machine receives
the last page of the print job. If transmission is timed out, the print job will be canceled.
Therefore, you should consider the machine usage when you set the time duration.