Power Saver Settings; Audio Tones - Fuji Xerox ApeosPort-V C5580 Administrator's Manual

5 Tools
Note

Power Saver Settings

You can configure the following settings of Power Saver mode.
Power Saver Timers
The Power Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the machine switches to these modes in the following order to
reduce power consumption.
Last operation on the machine  Low Power mode  Sleep mode
For more information on Low Power Mode and Sleep Mode, refer to "2 Product Overview" > "Energy Saver Mode" in the User
Guide.
Note
 From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
 From Last Operation to Sleep Mode
5
Specify a time period between 1 to 240 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note
Power Saver Deactivation
Set whether to disable the Energy Saver mode fully or partially when exiting the mode.
 Deactivate All
All devices of the machine exit the Energy Saver mode.
 Deactivate Partially
Only the devices necessary for the operation exit the Energy Saver mode.
You can select from [Always On] or [When Printing / Job Auto Processing].

Audio Tones

Select whether to sound an alarm when a job ends or a fault occurs.
Control Panel Select Tone
Set the volume to be sounded when a button on the control panel is correctly selected.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
Control Panel Alert Tone
Set the volume to be sounded when a button that cannot be selected is selected, or an error
occurs.
You can select from [Soft], [Normal], and [Loud]. To disable the sound, select [Off].
140
• When you send a print job that contains a large amount of data or a print job whose contents take a
while to be processed, transmission may be timed out before the machine receives the last page of
the print job. If transmission is timed out, the print job will be canceled. Therefore, you should
consider the machine usage when you set the time duration.
• You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
• Configure the [From Last Operation to Sleep Mode] time to be longer than the [From Last Operation
to Low Power Mode] time.