Fuji Xerox ApeosPort-IV C7780 Administrator's Manual page 512

15 Problem Solving
Error Code
026-721
026-722
026-723
026-724
026-725
026-726
026-727
026-730
027-400
027-442
15
027-443
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
512
[Cause] An error occurred while operating the Store to USB service.
[Remedy] Check the following conditions:
The USB memory device is inserted into the USB memory slot.
The USB memory device is accessible from your computer.
The unencrypted USB memory device is used.
[Cause] The USB memory device is not initialized.
[Remedy] Initialize the USB memory device on a computer with the following file
format, and then execute the operation again.
Supported file formats: FAT12, FAT16 (FAT), FAT32
Note • NTFS is not supported.
• A software-encrypted USB memory device is not supported.
If the error still is not resolved, contact our Customer Support Center.
[Cause] The machine failed to access to the medium.
[Remedy] 1) Check that the medium is not inserted or removed, or the other medium
is not inserted, while the machine is referencing the medium.
2) Check that the file in the medium can be accessed via a computer.
[Cause] An error occurred while connecting to EP system via the Internet.
[Remedy] Contact our Customer Support Center.
[Cause] The machine configuration information at a print job specification does not
match the actual machine configuration.
[Remedy] Modify the machine configuration information in the print driver screen to
match the actual machine configuration.
[Cause] Probable causes are as follows:
1) Unusable characters are included in the path name of the file location.
2) The length of the path name of the file location (including extension)
exceeds the number of characters available.
[Remedy] Take one of the following measures:
1) Change the path name of the file location.
2) Set the path in the range of 1 to 255 bytes.
[Cause] The size of paper loaded in the specified tray is unknown.
[Remedy] Check whether the paper guides are correctly positioned in the tray, and
then try again.
[Cause] Communications with the machine failed.
[Remedy] If other messages are displayed, confirm their content. If the control panel
is being operated, terminate the operation. If remote access is being
executed, wait until it completes. If the error still is not resolved, switch off
the machine power, make sure that the touch screen is blank, and then
switch on the machine power.
If the problem persists, contact our Customer Support Center.
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 1] for IPv6 on the machine, or the IP
address of IPv6 on the network device, to remove the duplication of
addresses.
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Auto Stateless Address 2] for IPv6 on the machine, or the IP
address of IPv6 on the network device, to remove the duplication of
addresses.
Cause and Remedy