Energy Saver Mode - Fuji Xerox ApeosPort-IV C7780 Administrator's Manual

Energy Saver Mode

The machine is equipped with the Energy Saver mode that reduces the power
consumption by saving the electricity to the machine when no copy or print data is
received for a specified time.
The Energy Saver has two modes: the Low Power mode and the Sleep mode.
When you do not use the machine for a specified period of time, the machine enters
the Low Power mode.
When time exceeds the time specified in the Low Power mode, the machine then
enters the Sleep mode.
Press the <Energy Saver> button on the control panel to enter the Energy Saver mode.
Low Power Mode
The Low Power mode reduces the power to the control panel and the fusing unit.
It extinguishes the touch screen and lights up the <Energy Saver> button on the control
panel. To activate the machine, press the <Energy Saver> button. Pressing the
<Energy Saver> button extinguishes the light and deactivates the Energy Saver mode.
Sleep Mode
The Sleep mode reduces the power to the machine even more than the Low Power
mode.
It extinguishes the touch screen and lights up the <Energy Saver> button on the control
panel. To activate the machine, press the <Energy Saver> button. Pressing the
<Energy Saver> button extinguishes the light and deactivates the Energy Saver mode.
It takes longer time than the Low Power mode to deactivate the Sleep mode and be
enable to use the machine.
Note • When you press the <Energy Saver> button during the Energy Saver mode, the touch
• When you make the machine exit Energy Saver mode by pressing the <Energy Saver>
• If you replace toner cartridges or supply paper during the Energy Saver mode, the machine
• The Energy Saver mode is not exited by the following operations:
• When the following device is connected to the machine and a user performs the following
• When the machine enters the Low Power mode during a user is authenticated, the machine
screen lights up. At this point, the scanner and the output devices remain in the Energy
Saver mode. Afterwards, by operations such as using the touch screen and opening or
closing of the document cover, you can make the devices necessary to activate the machine
exit the Energy Saver mode and make the machine ready to start exiting the Energy Saver
mode.
button, the machine does not immediately identify the movements such as opening or
closing of the front cover. To make the machine identify these operations, operate the
control panel before opening the front cover.
does not identify these changes. Before performing these operations, exit the Energy Saver
mode by first pressing the <Energy Saver> button on the control panel and then pressing the
<Machine Status> button on the control panel.
• Secure print
• Faxes stored in folders
• Direct fax
• Accessing a folder of the machine using CentreWare Internet Services
operation, the Low Power mode can be deactivated without pressing the <Energy Saver>
button. If the machine is in the Sleep mode, however, the Sleep mode will not be deactivated
by the operation. By setting longer time to elapse until the machine enters the Sleep mode,
you can make the machine exit the Energy Saver mode without pressing the <Energy
Saver> button. For more information on how to change the time to elapse until the machine
enters the Sleep mode, refer to "Changing the Interval for Entering Energy Saver Mode"
(P.24).
• Touch the card to Embedded IC Card Reader (optional)
exits the authentication mode.

Energy Saver Mode

1
23