Fuji Xerox ApeosPort-IV C7780 Administrator's Manual page 487

Error Code
016-713 [Cause]
[Remedy] Enter the correct passcode.
016-714
[Cause]
[Remedy] Create a new folder or specify an existing folder.
016-716 [Cause]
[Remedy] Delete unnecessary files and users from the machine.
Refer to "12 Job Status" > "Printing and Deleting Stored Jobs" in the User Guide.
016-717
[Cause]
[Remedy] Take one of the following measures:
016-718
[Cause]
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature, and then
016-719 [Cause]
[Remedy] Increase the size of the print page buffer.
016-720
[Cause]
[Remedy] Confirm the print data and try printing again.
016-721
[Cause]
[Remedy] For 1), when printing by the Auto Paper selection, set one of the paper
Refer to "Paper Type Priority" (P.156).
016-722
[Cause]
[Remedy] Confirm the staple position and the paper size, and try printing again.
016-723
[Cause]
[Remedy] Confirm the punch position and the paper size, and try printing again.
016-724 [Cause]
[Remedy] Specify the staple and punch positions on the same side, and try printing
016-725
[Cause]
[Remedy] Do not use the Job Flow feature. Simply scan the document from the
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Cause and Remedy
The passcode entered does not match the passcode set on the folder.
The specified folder does not exist.
Unable to spool TIFF file because of insufficient hard disk space.
Unable to create a Transmission Report - Job Undelivered or a
Transmission Report because the transmission result information required
for creating the report is not stored in the machine's memory.
Execute the jobs for large size Internet fax documents (about 2GB) by
splitting each document to minimize memory or HDD usage.
If many scan or Internet fax documents are being processed, wait until
the jobs are completed to execute a new job.
After completing the job that you want to confirm in a report, do not
execute 200 or more jobs before printing the report.
Unable to process the PCL print data because of insufficient memory.
print again.
Unable to process the PCL print data because of insufficient print page
buffer.
An invalid command is included in PCL print data.
An error occurred during print processing. Probable causes are as follows:
1) Printing was instructed by the Auto Paper selection when [Paper Type
Priority] is set to [Auto Paper Off] for all paper in the [Common Service
Settings].
2) ESC/P-K command error
types to other than [Auto Paper Off] in [Paper Type Priority].
For 2), confirm the print data.
The staple position specified is not supported by the machine, or the paper
size specified is not supported by the finisher.
The punch position specified is not supported by the machine, or the paper
size specified is not supported by the finisher.
The specified staple and punch position combination is unsupported.
again.
A scanned document stored in a folder was to be sent by fax using the Job
Flow feature, but the file in the folder could not be converted to fax data.
machine's [Fax] screen to send it by fax.
Error Code
15
487