Fuji Xerox ApeosPort-IV C7780 Administrator's Manual page 490

15 Problem Solving
Error Code
016-752
016-753
016-755
016-756
016-757
016-758
016-759
016-760
016-761
016-762
016-763
016-764
016-765
016-766
016-767
15
016-768
016-769
016-770
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
490
[Cause] Unable to process for PDF Bridge because of insufficient memory space.
[Remedy] Change the [Image Quality] setting from [High Resolution] to [High
Quality], or from [High Quality] to [Standard]. Or, add memory.
[Cause] The password entered does not match that of the PDF file.
[Remedy] Set the correct password on ContentsBridge.
[Cause] Attempted to process a print-protected PDF file.
[Remedy] Cancel the print protection using Adobe Reader
[Cause] Do not have permission to use the service.
[Remedy] Consult your system administrator.
[Cause] The passcode is incorrect.
[Remedy] Enter the correct passcode.
[Cause] The division does not have permission to use the service.
[Remedy] Consult your system administrator.
[Cause] The number of pages reached the maximum number of pages for this
service.
[Remedy] Consult your system administrator.
[Cause] An error occurred during PostScript (optional) processing.
[Remedy] Take one of the following measures:
Set [Image Quality] to [High Speed].
Increase PostScript memory.
For more information on [Image Quality], refer to the help of the print driver. For more
information on memory, refer to "Allocate Memory" (P.215).
[Cause] An error occurred during image processing.
[Remedy] Set [Image Quality] to [Standard] and execute the operation again. If the
error still is not resolved, set [Print Page Mode] to [On].
[Cause] The specified printer language is not installed on the machine.
[Remedy] For [Parallel] and [USB] in [Print Mode] under [Port Settings], specify
correct printer language.
[Cause] Unable to connect to the POP server.
[Remedy] Confirm the POP server IP address set on the machine.
[Cause] Unable to connect to the SMTP server.
[Remedy] Consult the SMTP server administrator.
[Cause] Unable to send the e-mail because the hard disk on the SMTP server is
full.
[Remedy] Consult the SMTP server administrator.
[Cause] An error occurred on the SMTP server.
[Remedy] Consult the SMTP server administrator.
[Cause] Unable to send the e-mail because the address is not correct.
[Remedy] Confirm the address, and try sending again.
[Cause] Unable to connect to the SMTP server because the machine's mail
address is incorrect.
[Remedy] Confirm the machine's mail address.
[Cause] The SMTP server does not support delivery receipts (DSN).
[Remedy] Send e-mail without setting delivery receipts (DSN).
[Cause] Direct Fax is restricted.
[Remedy] Consult your system administrator whether Direct Fax is available. If it is
available, contact our Customer Support Center.
Cause and Remedy
®
, and try printing again.