Fuji Xerox ApeosPort-IV C7780 Administrator's Manual page 194

Hide thumbs Also See for ApeosPort-IV C7780:

Table of Contents

Added Port Number

Select [Disabled] when you want to set the machine does not accept IPP from other than the

standard port number, or select [Enabled] when accepts all port numbers.

Enter a port number for IPP other than the standard port number from 1 to 65535.

To disable this option, enter "0".

The default value is 80.

Important • Using the default port number may cause the conflict with other ports. Confirm that the port

Select [Enabled] to use EtherTalk

Select [Enabled] to use Bonjour.

Select [Enabled] to use Port9100.

Select this option when the communication protocol is in RAW format for Windows Standard

TCP/IP port monitor.

Enter a port number for Port9100 from 1 to 65535.

The default value is 9100.

Important • Do not use the numbers assigned to the other ports.

Select [Enabled] to use SNMP, when you use any web applications manufactured by Fuji

Xerox to control the machine on the network.

Select [Enabled] to use SIP, when you use IP fax (SIP) transmission.

SIP Port Number

Enter a port number to use IP fax (SIP).

The default value is 5060.

Important • Do not use any numbers assigned to other ports.

Select [Enabled] when you use the Scan to PC service with FTP transmission.

numbers assigned to the other ports are not used.

• [Added Port Number] cannot be configured if [Port Status] is set to [Disabled].

To configure [Added Port Number], enable port status and reboot the machine, and then

configure [Added Port Number].

• The Adobe PostScript 3 Kit (optional) is required.

• The Adobe PostScript 3 Kit (optional) is required to use the port. However, for Mac OS ® X

10.4.11 or later, you can use the port without the Adobe PostScript 3 Kit (optional).

• To print from a printer detected by [Bonjour], the LPD port must be activated in advance.

• IP fax (SIP) is not available for some models.

Show Quick Links

Chapters

Table of Contents