Fuji Xerox ApeosPort-IV C7780 Administrator's Manual page 511

Error Code
026-705 [Cause]
[Remedy] Change the [Image Quality] setting from [High Resolution] to [High
026-706
[Cause]
[Remedy] Release the print prohibited settings using DocuWorks Viewer, and then
026-707
[Cause]
[Remedy] Set the correct password on ContentsBridge.
026-708 [Cause]
[Remedy] Take one of the following measures:
026-709
[Cause]
[Remedy] Wait around one day, and when capacity becomes available as a result of
026-710
[Cause]
[Remedy] Take one of the following measures:
026-711
[Cause]
[Remedy] Take one of the following measures:
026-712
[Cause]
[Remedy] Retry after waiting for a while.
026-718
[Cause]
[Remedy] Confirm the print data, and try printing again.
026-719
[Cause]
[Remedy] Wait for a while and execute the operation again. If the error still is not
026-720
[Cause]
[Remedy] Confirm the amount of available space.
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Cause and Remedy
Unable to process for DocuWorks documents because of insufficient
memory space.
Quality], or from [High Quality] to [Standard]. Or, add memory. If the error
still is not resolved, increase memory. If the problem persists even after
adding memory to the maximum capacity, print using the print driver (PCL,
etc.) from DocuWorks Viewer.
Attempted to print a DocuWorks document of which printing is prohibited.
execute the operation again.
When processing password-protected DocuWorks documents, the
password entered does not match that of the DocuWorks document.
Exceeded the maximum limit for the scan data size that can be stored for
one job with Store & Send Link.
1) Reduce the resolution (scan quality) of the scan parameters and
execute the operation again.
2) Reduce the image with magnification of the scan parameters (such as
A3 > A4) and then execute the operation again.
3) If [Store & Send Link - Maximum File Size] is set to a small value,
increase the value.
The capacity of the hard disk that can be used to store scan data with
Store & Send Link is insufficient.
the automatic deletion of files, execute the operation again.
The machine has received and e-mail encrypted by S/MIME, but does not
support the encryption method.
Ask the sender to send the e-mail encrypted by 3DES.
Disable the FIPS140 validation mode of the machine.
Exceeded the maximum size allowed for a multi-page file when scanning.
1) Reduce the resolution (scan quality) of the scan parameters and
execute the operation again.
2) Reduce the number of document pages and then execute the operation
again.
The maximum size is 2 GB for TIFF, XPS, and PDF, and 1 GB for XDW.
An error occurred while operating from CentreWare Internet Services.
Incompatible print parameters are used. The combination of the specified
features such as Document Size, Paper Size, Paper Tray, 2 sided printing,
and Output Tray is incompatible.
An error occurred while operating the Store to USB service.
resolved, contact our Customer Support Center.
The capacity of the USB memory device of the recipient is insufficient
while performing the Store to USB service.
Error Code
15
511