Fuji Xerox ApeosPort-IV C7780 Administrator's Manual page 671

Extended Settings
Parameter Item No.
Auto layout 106
Active palette 107
No. of prints 108
Output 109
destination
2 sided printing 110
Alphanumeric 112
fonts
Position 113
adjustment (Vertical
position
adjustment)
114
(Horizontal
position
adjustment)
Number of sets 115
Selects whether to perform auto layout of the document or not.
[0] (Default) : ON
[1] : OFF
Selects whether to use a pen specified by command or set on the panel.
[0] (Default) : Command
[1] : Panel
Sets the number of copy to be printed.
[1] 250] (Default: 1) : 1 - 250
- [
Sets the output tray for the printouts.
[0] (Default) : Right Top Tray
[80] : Right Middle Tray
Sets 2 sided printing.
[0] (Default) : None
[1] : Head to head
[2] : Head to toe
Sets the font for single-byte characters.
For more information on fonts, refer to "Internal Fonts" (P.613).
[0] (Default) : Stroke
[1] : Roman
[2] : Sans serif
Adjusts the hard clip area vertically or horizontally. You can set from -250
mm to +250 mm in 1 mm increments.
[0] (Default) : Does not move the hard clip area.
[1] - [250] : -250 to -1 mm
[251] - [500] : +1 to +250 mm
Important • Data outside the printable area is not printed regardless of the
adjustment of the print position. In addition, data moved outside the
printable area as a result of adjusting the print position is not printed.
Sets the method for specifying the print sets.
[0] (Default) : Protocol
[1] : Panel
[2] : Command
HP-GL/2 Emulation
Value
16
671