Printable Area - Fuji Xerox ApeosPort-IV C7780 Administrator's Manual

16 Appendix

Printable Area

The area on paper that can be printed is as follows.
Standard Printable Area
The standard printable area is an area on paper excluding the 4 mm margins on all four
edges of paper. For 13
excluding the 3.5 mm left and right margins. The actual printable area, however, may
vary depending on the printer (plotter) control language.
Extended Printable Area
With the extended printable area setting, for printing, both the printable area and the
print assured area can be extended to 323
the printable area and the print assured area can be extended to 317
maximum.
The un-printable area, however, may vary depending on the size of paper.
Note
For the setting method on the print driver, refer to the help provided for the print driver. For more about
the setting on the control panel, refer to "Print Area" (P.217).
16
612
× 18" (320 mm width), the printable area is an area on paper
• To extend the print area, change the PCL print driver setting, or the [Print Area] setting on
the touch screen.
When the paper width is 12.6 inches
(320 mm width)
Unprintable Area
4mm
Printable Area/
Print Assured Area
3mm
Paper feed direction
4mm
Unprintable Area
4mm
Printable Area/
Print Assured Area
3mm
Paper feed direction
4mm
× 480 mm at a maximum. For copying, both
When the paper width is 330mm
(320 mm width)
Unprintable Area
6.5mm
3mm 3.5mm
Paper feed direction
Unprintable Area
3mm 16.5mm
Paper feed direction
× 432 mm at a
4mm
6.5mm
Print Assured Area
3.5mm
4mm
Printable Area
4mm
Printable Area/
Print Assured Area
16.5mm
52mm