Battery Charging; Battery Removal - Polaris 2015 RZR 900 Service Manual

Battery Charging

If battery voltage is less than 12.6 Vdc, the battery may
need recharging. When using an automatic charger, refer
to the charger manufacturer's instructions for recharging.
Do not exceed 6 amps when charging the battery.
NOTE: Charge the battery using an automatic
charger that will not exceed 14.6 Vdc. An automatic
charger will signal when charging is complete.
Allow the battery to stand disconnected for at least
1-2 hours after being properly charged. If the voltage
drops below 12.6 volts, charging was ineffective or
the battery needs to be replaced.
WARNING
An overheated battery could explode, causing severe
injury or death. Always watch charging times carefully.
Stop charging if the battery becomes very warm to the
touch. Allow it to cool before resuming charging.
VOLTAGE
STATE OF
(DC)
CHARGE
12.8 or
100%
more
75% -
12.6 - 12.8
100%
50% - 75% 12.3 - 12.6
25% - 50% 12.0 - 12.3
0% - 25% 12.0 or less
NOTE: Follow the charger instructions supplied by
the manufacture regarding the order or connections,
switch positions and when to connect the charger to
an outlet.
CHARG-
ACTION
E TIME
None, check
None
again in 3
Required
months
May need
3 - 6 hrs
slight charge
Needs
5 - 11 hrs
Charge
Needs
At least
Charge
13 hrs
Needs
At least
Charge
20 hrs
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.

Battery Removal

1. Remove the driver's seat to access the battery
2. Disconnect the black (negative) battery cable.
CAUTION
To reduce the chance of sparks: Whenever removing
the battery, disconnect the black (negative) cable first.
When reinstalling the battery, install the black (negative)
cable last.
3. Disconnect the red (positive) battery cable.
4. Remove the battery hold-down bracket
5. Lift the battery out of the vehicle.
MAINTENANCE
.
1
2
.
2.29