Battery Charging / Off Season Storage; Battery Removal; Battery Installation - Polaris 2014 RZR XP 1000 Service Manual

MAINTENANCE

Battery Charging / Off Season Storage

Refer to Charging Procedure , page 10.36and Battery
Off Season Storage, page 10.35.

Battery Removal

1. Remove the driver's seat to access the battery (Item
1).
NOTE: Battery is located under left rear seat on
RZR XP 4 1000
2. Disconnect the black (negative) battery cable(s).
3. Disconnect the red (positive) battery cable(s).
CAUTION
To reduce the chance of sparks: Whenever removing
the battery, disconnect the black (negative) cable first.
When reinstalling the battery, install the black (negative)
cable last.
4. Remove the battery hold-down bracket (Item 2).
5. Lift the battery out of the vehicle.
2.30

Battery Installation

NOTE: Using a new battery that has not been fully
charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance.
Refer to
installing the battery.
1. Ensure the battery is fully charged.
2. Place the battery in the battery holder and secure
with hold-down strap.
3. Coat the terminals with dielectric grease or
petroleum jelly.
4. Connect and tighten the red (positive) cable(s) first.
5. Connect and tighten the black (negative) cable (s)
last.
6. Verify that cables are properly routed and reinstall
the driver's seat.
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
Charging Procedure , page 10.36before