Polaris 2015 RZR 900 Service Manual page 126

ENGINE / COOLING SYSTEM
5. Using a dial bore gauge, measure big end I.D. in two
directions shown. Remove bearings when taking
measurements . Record measurements and
1
compare to specifications.
6. Refer to the number printed onto the side of the
connecting rod, closest to the small bore end. This
number represents the bore diameter.
7. The table below lists the big end bore diameter
specifications.
Connecting Rod Big End Bore Diameters
1
1.7318- 1.7321-
1.7321" 1.7323"
(43.989- (43.996-
43.996 mm) 44.003 mm)
8. Whether using new connecting rods or re-installing
the original ones, refer to the bearing selection chart
provided in the "Connecting Rod Bearing Selection"
procedure in this chapter.
3.60
2 3
1.7323-
1.7326"
(44.003-
44.010 mm)
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.