Battery Removal / Installation; Battery Charging / Off Season Storage; Engine / Chassis Electrical Ground - Polaris Ranger RZR XP 900 2011 Service Manual

MAINTENANCE
Battery Removal
1. Remove the driver's seatto access the battery.
2. Disconnect the black (negative) battery cables.
3. Disconnect the red (positive) battery cables.
A
CAUTION
To reduce the chance of sparks: Whenever
removing the battery, disconnect the black
(negative) cable first. When reinstalling the
battery, install the black (negative) cable last.
4. Remove the hold-down strap and lift the battery out of the
vehicle.
Battery Installation
IMPORTANT: Using a new battery that has not been
fully charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance.
Follow the battery charging procedure in Chapter 10
"Electrical" before installing the battery.
1. Ensure the battery is fully charged.
2.30
2. Place the battery in the battery holder and secure with hold-
down strap.
3. Coatthe terminals with dielectric grease or petroleum jelly.
4. Connect and tighten the red (positive) cables first.
5. Connect and tighten the black (negative) cables last.
6. VerifY that cables are properly routed and reinstall the
driver's seat.
Battery Charging I Off Season Storage
Refer to Chapter 10 "Electrical" for charging and off season
storage procedures.
Engine I Chassis Electrical Ground
Inspect the ground cable connections. Remove ground terminals
and clean if necessary.
1. Remove the driver's seat and locate the start solenoid
behind the battery box.
2. Inspect the ground terminals located below the solenoid. Be
sure they are clean and tight.
9923144 - 2011 RANGER RZR XP 900 Service Manual
© Copyright 2011 Polaris Sales Inc.