Rear Control Arm Installation - Polaris 2015 RZR 900 Service Manual

6. If not replacing the A-arm, thoroughly clean the A-arm
and pivot tubes.
7. Insert new bushings and pivot tubes into new A-arm.

Rear Control Arm Installation

1. Install lower control arm assembly onto vehicle frame.
Torque new fasteners to specification.
2. Attach lower control arm to bearing carrier. Torque
new fastener to specification.
3. (RZR 60" ONLY) Mount stabilizer bar to lower control
arm. Torque fasteners to specification.
4. Route brake line on top of the lower control arm.
5. Install upper A-arm assembly onto vehicle frame.
Torque new fastener to specification.
6. Install the lower portion of the shock to the lower
control arm. Torque shock fastener to specification.
7. (RZR 50" and XC ONLY) Mount stabilizer bar to
upper control arm. Torque fasteners to specification.
8. Attach upper A-arm to bearing carrier. Torque new
fastener to specification.
9. Install wheel and torque wheel nuts to specification.
Upon A-arm installation completion, test vehicle at low
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
STEERING / SUSPENSION
CAUTION
speeds before putting into service.
Rear Upper / Lower A-arm Bolts:
42 ft-lb (57 Nm)
Lower Rear Bearing Carrier Bolts:
42 ft-lb (57 Nm)
Stabilizer Linkage Fasteners:
40 ft-lbs (54 Nm)
Shock Mounting Bolts:
42 ft-lb (57 Nm)
Upper Rear Bearing Carrier Bolts:
42 ft-lb (57 Nm)
8
8.21