Polaris 2015 RZR 900 Service Manual page 136

ENGINE / COOLING SYSTEM
13. Torque the upper crankcase bolts in sequence to
specification (start with #12). Repeat the sequence
to verify final torque.
Upper Crankcase Bolts:
M8 Bolts:
26 ft-lb (35 Nm)
M6 Bolts:
9 ft-lb (12 Nm)
14. Rotate the engine so the cylinder is facing down.
15. Install a new seal on the oil pump.
16. Lift the oil pump drive chain and install the oil pump.
3.70
17. Install dowel pins
18. Install the three bolts
crankcase. Torque mounting bolts to specification.
19. Reinstall oil pump pick-up
Torque mounting screws to specification.
20. Clean the gasket sealing surfaces on oil sump cover
and crankcase to remove old gasket material and
any oil.
NOTE: Gasket surfaces must be DRY and oil
free. Use care upon assembly to keep oil away.
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
into oil pump mounting holes.
10
that retain oil pump
13
Oil Pump Mounting Bolts:
7 ft-lbs (10 Nm)
if previously removed.
11
Oil Pump Pick-Up Retaining Screws:
7 ft-lb (10 Nm)
to the
12