Cps Replacement - Polaris 2015 RZR 900 Service Manual

3. If the resistance is correct:
• Test the main harness circuit between the sensor
connector terminals and the corresponding pin
terminals at the ECU (see wiring diagram).
• Check the sensor mounting, air gap, flywheel
encoder ring for damage or runout, and flywheel
key. Inspect CPS and flywheel encoder ring for
damage (see Chapter 4 –
page 4.27.
4. If the resistance is incorrect, follow the
Replacement, page 4.27 procedure.

CPS Replacement

1. Access the CPS harness from the right rear side of
the vehicle.
2. Disconnect the CPS harness connector.
CPS Replacement,
CPS
3. Remove CPS retaining bolt
4. Remove CPS wire lead from wire clip
5. Install new sensor using a light coating of oil on the
O-ring to aid installation.
6. Torque CPS retaining bolt to specification.
7. Route CPS wire lead through wire clip and reconnect
CPS harness connector.
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
FUEL SYSTEM
and remove the sensor
1
from the stator cover.
CPS Retaining Bolt:
9 ft-lb (12 Nm)
4
.
4.27