Polaris 2015 RZR 900 Service Manual page 237

SITUATION PROBABLE CAUSE
Plugged air intake or outlet.
Belt slippage due to water, oil, grease, etc.,
rubbing on cover.
PVT cover
Clutches or weight being applied to cover
overheating
while in operation.
(melting)
High vs. low range.
Cover seals or ducts leaking
Water ingestion
Operator error
Belt worn out
Water ingestion
Belt slippage
Belt contaminated with oil or grease
Belt worn or separated, thin spots, loose belt
PVT noise
Broken or worn clutch components, cover
hitting clutches
Thin spots on belt, worn belt
Engagement
erratic or stabby
Drive clutch bushings stick
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
PVT SYSTEM
REMEDY
Clear obstruction
Inspect system. Clean , repair or replace as
necessary. Seal PVT system ducts.
Remove weight. Inform operator.
Instruct operator on guidelines for operation in
proper driving range for different terrain as
outlined in Owner's Safety and Maintenance
Manual.
Find leak and repair as necessary.
Instruct operator on guidelines for operation in
wet terrain as outlined in Owner's Safety and
Maintenance Manual.
Replace belt.
Inspect and seal PVT system.
Inspect and clean.
Replace belt.
Inspect and repair as necessary.
Replace belt. Refer to belt burnt troubleshooting
and instruct operator.
Inspect and repair clutches.
5
5.35