Polaris 2015 RZR 900 Service Manual page 293

12. Grease the joint with the special joint grease
provided in the boot replacement kit. Fill the cavity
behind the balls and the splined hole in the joint's
inner race. Pack the ball tracks and outer face flush
with grease. Place any remaining grease into the
boot.
CAUTION
The grease provided in the replacement kit is specially
formulated for wear resistance and durability. DO NOT
use substitutes or mix with other lubricants.
NOTE: The amount of grease provided in the
boot kit is pre-measured. Use entire contents of
package.
13. Fully compress the joint and push the drive shaft
firmly into the inner race.
14. Align the circlip with the lead-in chamfer.
15. Use a soft-faced hammer to tap the joint onto the
drive shaft until you reach the end of the splines and
the joint locks in place.
16. Pull on the joint to test that the circlip is seated and
that the joint is securely fastened to the shaft.
17. Remove excess grease from the plunging joint's
external surfaces and place the excess grease in the
boot.
18. Pull the boot over the joint and position the boot lips
into the grooves on the joint housing and shaft. Make
sure the boot is not dimpled or collapsed.
19. Install and tighten the small clamp
20. Pull out on the drive shaft to center the joint in the
21. Position the boot lip in its groove. Install and tighten
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
housing. Slide a straight O-ring pick or a small
slotted screw driver between the large end of the
boot and the joint housing and lift up to equalize the
air pressure in the boot.
the large clamp using the appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
FINAL DRIVE
using the
7
7.19