Battery; Battery Specifications; Battery Removal; Battery Installation - Polaris 2015 RZR 900 Service Manual

BATTERY

Battery Specifications

Battery Removal

1. Remove the driver's seat to access the battery
2. Disconnect the black (negative) battery cable.
CAUTION
To reduce the chance of sparks: Whenever removing
the battery, disconnect the black (negative) cable first.
When reinstalling the battery, install the black (negative)
cable last.
3. Disconnect the red (positive) battery cable.
4. Remove the battery hold-down bracket
5. Lift the battery out of the vehicle.

Battery Installation

NOTE: Using a new battery that has not been fully
charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance.
Refer to
installing the battery.
.
1
1. Ensure the battery is fully charged.
2. Place the battery in the battery holder and secure
with hold-down bracket. Torque bracket fastener to
specification.
3. Coat the terminals with dielectric grease or petroleum
jelly.
4. Connect and tighten the red (positive) cable (s) first.
Torque fasteners to specification.
5. Connect and tighten the black (negative) cable (s)
last.
.
6. Verify that cables are properly routed and reinstall the
driver's seat.
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
ELECTRICAL
Battery Charging, page 2.29 before
Battery Hold-Down Bracket:
8 ft-lb (11 Nm)
Battery Terminal Fasteners:
60 in-lb (7 Nm)
11
11.19