Engine Break - Polaris 2015 RZR 900 Service Manual

26. Fill the cooling system with coolant and bleed the
system. See Chapter 3 – Cooling System Bleeding,
page 3.15
27. Connect the battery.
specification.
Battery Terminal Fasteners:
60 in-lb (7 Nm)
Engine Break-In
The break-in period consists of the first 25 hours of
operation, or the time it takes to use 15 gallons (57 liters)
Torque fasteners to of fuel. Careful treatment of a new engine and drive
components will result in more efficient performance and
longer life for these components.
1. Fill fuel tank with unleaded fuel which has a minimum
2. Refer to Chapter 2 – Engine Oil Level, page 2.14.
3. Drive slowly at first to gradually bring engine up to
4. Vary throttle positions. Do not operate at sustained
5. Perform regular checks on fluid levels, controls and
6. Change oil and oil filter after 25 hour break-in period.
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
ENGINE / COOLING SYSTEM
CAUTION
Use only Polaris PS-4 or PS-4 Extreme Duty Synthetic
4-Cycle Engine Oil.
Never substitute or mix oil brands. Serious engine
damage and voiding of warranty can result.
Do not operate at full throttle or high speeds for
extended periods during the first three hours of use.
Excessive heat can build up and cause damage to
close fitted engine parts.
pump octane number of 87 = (R + M)/2.
Check oil level indicated on dipstick. Add oil if
necessary.
operating temperature.
idle or sustained high speed.
all important bolt torques.
3
3.33