Inner Plunging Joint / Boot Replacement - Polaris 2015 RZR 900 Service Manual

18. Install and tighten the large clamp
appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226
19. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize
in the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
20. Install and tighten the small clamp
using the appropriate clamp tool.
Axle Boot Clamp Tool: PU-48951
or
CV Boot Clamp Pliers: 8700226

Inner Plunging Joint / Boot Replacement

using the
1. Use a side cutters to cut and discard the boot clamps
2. Remove the large end of the boot from the plunging
on the boot
3. Clean the grease from the face of the joint and place
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
.
1
joint and slide the boot down the shaft.
the drive shaft in a soft-jawed vise.
FINAL DRIVE
7
7.17