Driven Clutch Assembly - Polaris 2015 RZR 900 Service Manual

10. Check the rollers for wear. If rollers are worn, a
new driven clutch assembly may be needed if there is
damage to the helix.
11. If roller need replacement, remove the E-clip
washer retaining each roller.
12. Inspect driven clutch sheave faces for wear or
damage.
13. Clean and inspect the helix and transmission input
shaft splines.
14. Lube splines with a light film of grease. Do not
lubricate the bearings!

Driven Clutch Assembly

1. Align the "X" marks on each of the sheaves during
reassembly.
and
2. Assemble the clutch sheaves.
3. Position the spring, spring cup and retaining ring into
moveable sheave. Do not apply oil or grease to the
bearings.
4. Place the clutch into the universal clutch compressor.
Apply and hold downward pressure on the spring cup.
Torque the retaining ring bolts to specification.
5. Install driven clutch assembly and drive belt.
9925723 R01 - 2015 RZR 900 Service Manual
© Copyright 2014 Polaris Industries Inc.
PVT SYSTEM
Clutch Spring Retaining Ring Bolts:
12 ft-lb (16 Nm)
5
5.33