Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 748

Z-FL-CH Set Z-fold stapleable quantity: Fin-B1
Lv.1 Details To set the maximum number of stitch pages in Z-fold stapling.
This item is used to prevent missing pages in Z-fold stapling by
decreasing the maximum number of stitch pages.
Use case When missing pages occurs in Z-fold stapling
Adj/set/operate method Enter the setting value, and then press OK key.
Display/adj/set range 0 to 1
0: 10 sheets, 1: 5 sheets
Default value 0
5
5-520
SORTER> ADJUST
FUNCTION
FN-SENS1
Lv.1 Details
Use case
Adj/set/operate method Select the item, and then press OK key.
T-5-96
FN-SENS2
Lv.1 Details
Use case
Adj/set/operate method Select the item, and then press OK key.
FIN-BK-R
Lv.1 Details
Use case
Adj/set/operate method Select the item, and then press OK key.
Display/adj/set range
Required time
Related service mode
FIN-BK-W
Lv.1 Details
Use case
Adj/set/operate method Select the item, and then press OK key.
Display/adj/set range
Required time
Related service mode
VR1-A4R
Lv.1 Details
Use case
Adj/set/operate method 1) Set the A4R paper on the Inserter Upper Tray and align it with the
SORTER> FUNCTION
Adj punched ppr size sensor output: Bklt
To automatically adjust the output of A3/LDR/B4/A4R/B5R Sensors
on the Finisher Punch Unit in order.
• When installing/replacing the Punch Unit
• When replacing the Punch Waste Sensor
• When replacing the Finisher Controller PCB
Adj Punch Waste Sensor output: Booklet
To automatically adjust the output of Punch Waste Sensor on the
Finisher Punch Unit.
• When installing/replacing the Punch Unit
• When replacing the Punch Waste Sensor
• When replacing the Finisher Controller PCB
Controller PCB backup data read: Staple
To read the backup data from Finisher Controller PCB and save to
the hard disk.
When replacing the Finisher Controller PCB
In processing: ACTIVE, At normal termination: OK, At abnormal
termination: NG
Approx. 5 minutes
SORTER> FUNCTION> FIN-BK-W
Controller PCB backup data write: Staple
To write the backup data saved on the hard disk to Finisher
Controller PCB.
When replacing the Finisher Controller PCB
In processing: ACTIVE, At normal termination: OK, At abnormal
termination: NG
Approx. 5 minutes
SORTER> FUNCTION> FIN-BK-R
Adj Upr Tray width volume (A4R):Inserter
To adjust the paper minimum width (A4R) of Inserter Upper Tray
automatically.
When the size mismatch jam is incorrectly detected at the pickup
from Inserter Upper Tray
width of Slide Guide.
2) Select the item, and then press OK key.