Canon imageRUNNER ADVANCE 9070 PRO series Service Manual Digest page 441

■ PASCAL
COPIER> ADJUST> PASCAL
OFST-P-Y Y density adj at test print reading
Lv.1 Details To adjust the offset of Y color test print reading signal at Auto Adjust
Gradation (Full Adjust).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the greater value is set, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution Do not use this at the normal service.
Display/adj/set range -128 to 128
Default value According to the adjustment value of the Reader at factory shipment
OFST-P-M M density adj at test print reading
Lv.1 Details To adjust the offset of M color test print reading signal at Auto Adjust
Gradation (Full Adjust).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the greater value is set, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the adjustment value of the Reader at factory shipment
OFST-P-C C density adj at test print reading
Lv.1 Details To adjust the offset of C color test print reading signal at Auto Adjust
Gradation (Full Adjust).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the greater value is set, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the adjustment value of the Reader at factory shipment
COPIER> ADJUST> PASCAL
OFST-P-K Bk density adj at test print reading
Lv.1 Details To adjust the offset of Bk color test print reading signal at Auto Adjust
Gradation (Full Adjust).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the greater value is set, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the adjustment value of the Reader at factory shipment
T-5-37
5
5-213