Protocol Settings - Fuji Xerox ApeosPort-IV C5575 Administration Manual

WebDAV
Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network
Scanner Utility3 to access folders in the machine.
Note
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • Do not use a number that is the same as a port number of another port. However, you can use the
Operation Time-Out
You can enter an operation time-out period between 1 and 65535 seconds in 1 second
increments.
ThinPrint
Port Status
You can use the machine for print in the ThinPrint environment. The machine decompresses
and prints the compressed print data sent from the server.
Select [Enabled] when you use ThinPrint.
Port Number
Enter a port number for ThinPrint from 1 to 65535.
The default value is 4000.
Important • Do not use any number s assigned to the other ports.
Note

Protocol Settings

Set the parameters required for communications. In [Protocol Settings], you can set the
following items.
Ethernet Rated Speed
Set the communication speed for the Ethernet interface.
Auto
Select this to detect the Ethernet transmission rate up to 1 Gbps automatically.
100 Mbps Full-Duplex
Select this to set 100BASE-TX (Full Duplex) as the default value.
100 Mbps Half-Duplex
Select this to set 100BASE-TX (Half Duplex) as the default value.
• You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the machine,
and then configure [Port Number] and [Operation Time-Out].
same port number for a port that uses HTTP (IPP, Internet Services (HTTP), UPnP Discovery, SOAP,
WebDAV, and Web Services on Devices (WSD)).
• ThinPrint is available when the communication protocol uses IPv4.
• The maximum of three connections are possible at a time.
Connectivity & Network Setup
201
5