Changing The Paper Size For Tray 6 (Hcf B1) - Fuji Xerox ApeosPort-IV C5575 Administration Manual

2 Paper and Other Media

Changing the Paper Size for Tray 6 (HCF B1)

The following describes how to change paper size in Tray 6 (HCF B1).
1
Pull out the Tray 6 until it stops.
Make sure to pull out the tray slowly. If
the tray is pulled out with too much force,
the tray might possibly hit your knees or
other parts of your body and cause
injuries.
Important • While the machine is processing a job, do not
2
2
Remove any paper loaded in the tray.
3
Open the end guide (1) and unscrew the screw
(2). And then remove the guide from the tray.
4
Insert the small protrusions at the bottom of the guide into the holes corresponding to the
paper size (1). Insert the protrusion on the tray into a hole corresponding to the paper size
on the top of the guide, and tighten up the screw (2).
5
Unscrew the screw of the front guide and
remove the guide from the tray.
58
CAUTION
pull out the tray that is being used for the job.
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add
paper on top of any remaining paper in the tray.