Fuji Xerox ApeosPort-IV C5575 Administration Manual page 662

16 Appendix
Parameter
Stapling
Manual feed tray
check indicator
Punching
16
Number of holes
662
Item No.
159 (Scaling) Sets whether the original size is enlarged or reduced so that the document size
fits the paper size.
[0]
[1] (Default) : ON
160 (Scaling Selects the document size for auto scaling: A series paper (A0, A1, A2, A3, A4,
mode) and A6) or the active coordinate area which is determined accordance with
the setting selected in [Area Determination Mode].
[0] (Default) : Paper Size
[1]
Note
161 (Active Sets the method to obtain the active coordinate area when auto scaling is
area being used.
[0] (Default) : Auto
determination
command) [1]
[2]
[3]
[4]
Note
162 (Paper Sets the paper margin when auto scaling is being used.
margin) [0] - [99] (Default: 0)
Note
163 (Image Sets whether to perform image enhancement, which artificially increases the
enhancement) resolution of an image and smooth its edges.
[0]
[1] (Default) : ON
164 Sets the stapling position.
[0] (Default) : None
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
165 [0]
[1] (Default) : Yes
166 Select the position for punching holes.
[0]
[1] (Default) : Top
[2]
[3]
[4]
167 Select the number of punch holes.
[0] (Default) : 2 holes
[1]
[2]
Value
: OFF
: Active Coordinate Area
• [Active Coordinate Area] can be selected only when [Auto layout] is set to
[ON]. When [OFF] is selected, [Scaling mode] becomes [Paper Size].
• The setting of the scaling mode is valid when [Document size] is set to
[Auto].
: PS
: IW
: IP
: Adapted
• The setting of the active area determination command is valid when
[Document size] is set to [Auto].
: 0 to 99 mm
• The setting of the paper margin is valid when [Document size] is set to
[Auto].
: OFF
: Top Left
: Top Double
: Top Right
: Left Double
: Right Double
: Bottom Left
: Bottom Double
: Bottom Right
: Center
: None
: None
: Bottom
: Left
: Right
: 3 holes
: 4 holes