Changing The Interval For Entering Energy Saver Mode - Fuji Xerox ApeosPort-IV C5575 Administration Manual

1 Before Using the Machine
1

Changing the Interval for Entering Energy Saver Mode

This section describes the procedures for setting the Energy Saver mode.
To activate the Energy Saver, set the time to elapse until the machine enters the Low Power
mode as well as the time to elapse until the machine enters the Sleep mode.
Note
1
Press the <Log In/Out> button.
2
Enter the system administrator's user ID with
the numeric keypad or the keyboard displayed
on the screen, and select [Enter].
When a passcode is required, select [Next] and
enter the system administrator's passcode, and
select [Enter].
Note
24
- Private Charge Print
- Faxes stored in folders
- Direct Fax
- Accessing a folder of the machine using CentreWare Internet Services
• The control panel remains lit off and only the output devices exit the Energy Saver mode by the
following operations:
- Print
- Sample Print
- Print Fax
• When [Deactivation With Smart WelcomEyes] is set to [Enabled] under [Tools] > [System Settings] >
[Common Service Settings] > [Energy Saver Settings], and human presence is detected, the machine
automatically exits the Energy Saver mode.
• When the following device is connected to the machine and a user performs the following
operation, the Low Power mode can be deactivated without pressing the <Energy Saver> button. If
the machine is in the Sleep mode, however, the Sleep mode will not be deactivated by the operation.
By setting longer time to elapse until the machine enters the Sleep mode, you can make the
machine to exit the Energy Saver mode without pressing the <Energy Saver> button. For more
information on how to change the time to elapse until the machine enters the Sleep mode, refer to
"Changing the Interval for Entering Energy Saver Mode" (P.24).
- Touch the card to IC Card Reader (optional).
• When the machine enters the Low Power mode during a user is authenticated, the machine exits the
authentication mode.
• You can set the time to elapse until the machine enters the Low Power mode and the Sleep mode
from 1 to 240 minutes in 1 minute increments.
• When the interval setting specified for the Sleep Mode is the same as that specified for the Low
Power mode, the machine ignores the Low Power mode setting.
• The default user ID is "11111".
• The default passcode is "x-admin".
<Log In/Out> button