Step 2 Configuring The Snmp Port; Step 3 Configuration On The Computer - Fuji Xerox ApeosPort-IV C5575 Administration Manual

4
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
addresses. If an IP address cannot be obtained automatically or manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.201).
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
Select [Close].
Note
7
Print a configuration report to confirm that the SOAP, SNMP, and Internet Services (HTTP)
ports are enabled and that TCP/IP is set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.106).

Step 2 Configuring the SNMP Port

Configure the transport protocol for the SNMP port using CentreWare Internet Services.
1
Start CentreWare Internet Services.
For information on how to start CentreWare Internet Services, refer to "Starting CentreWare Internet Services" (P.312).
2
Configure the transport protocol for the SNMP port.
1) Click the [Properties] tab.
2) Click [
3) Click [Port Settings].
4) Select the [UDP] check box under [SNMP].
5) Click [Apply].
6) The right frame of the web browser changes to the machine reboot display.
7) Click [Reboot Machine]. The machine reboots and the settings are enabled.

Step 3 Configuration on the Computer

Create job flows using EasyOperator and Device Setup Tool to use for scanned documents.
Note
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
] on the left of [Connectivity].
• EasyOperator is included in the Driver CD Kit. Device Setup Tool is included in ApeosWare
Management Suite, which you can download from our web site. For information on creating job
flows, refer to the manual contained in the Driver CD Kit.
Configuration of Job Flow Sheets
9
359