Configuration Of Job Flow Sheets; Step 1 Enabling Ports And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-IV C5575 Administration Manual

9 Scanner Environment Settings

Configuration of Job Flow Sheets

This section describes how to configure the machine to use the Job Flow Sheets service.
The following shows the reference section for each procedure.

Step 1 Enabling Ports and Setting up TCP/IP

To use the Job Flow Sheets service, enable the SOAP, SNMP, and Internet Services (HTTP)
ports, and set an IP address and other addresses. The following describes the configuration
procedures on the machine.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools] on the [Services Home] screen.
2
Enable the SOAP port.
9
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SOAP], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Port Settings] screen is displayed.
3
Enable the SNMP port.
1) Select [SNMP], and then select [Change Settings].
2) Select [Port Status], and select [Change Settings].
3) Select [Enabled], and then select [Save].
4) Select [Close] repeatedly until the [Port Settings] screen is displayed.
5) Enable the Internet Services (HTTP) port as described above.
6) Select [Close] repeatedly until the [Tools] screen is displayed.
358
Step 1 Enabling Ports and Setting up TCP/IP ....................................................................................................................... 358
Step 2 Configuring the SNMP Port .......................................................................................................................................... 359
Step 3 Configuration on the Computer.................................................................................................................................. 359
• You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "CentreWare Internet Services Settings" (P.309).
displayed on the screen, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".