Fuji Xerox ApeosPort-IV C5575 Administration Manual page 548

15 Problem Solving
Error Code
033-535
033-536
033-537
033-538
033-539
033-540
033-541
033-542
033-543
033-544
033-545
033-546
033-547
033-548
033-549
033-550
033-551
033-552
15
033-553
033-554
548
[Cause] An error occurred during fax transmission.
[Remedy] Confirm information such as the recipient and folder information, and execute the
operation again.
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again.
[Cause] An error occurred during fax transmission.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
[Cause] The recipient is not specified.
[Remedy] Specify the recipient correctly.
[Cause] A line was specified that is not connected.
[Remedy] Specify a connected line.
[Cause] The recipient (fax number) is incorrect.
[Remedy] Enter a correct fax number, and execute the operation again.
[Cause] The recipient's line is busy.
[Remedy] Wait for a while, and then execute the operation again.
[Cause] The other machine may not be a facsimile.
[Remedy] Check whether the other machine is a facsimile.
[Cause] A dial tone was not detected.
[Remedy] Check whether the line is connected correctly.
[Cause] Communication was terminated by a cause such as pressing the <Stop> button.
[Remedy] No measure is required.
[Cause] Cannot transmit manually because a line is unavailable.
[Remedy] Establish communication such as by telephone, and execute the operation again.
[Cause] Cannot use the Fax service because of causes such as memory is insufficient.
[Remedy] Wait for a while, and execute the operation again.
[Cause] Cannot execute another job because fax communication is in progress.
[Remedy] Wait until the job being communicated completes, and then execute the operation
again.
[Cause] You attempted to change a job immediately before fax or telephone communication
completed.
[Remedy] Wait for a while, and execute the operation again.
[Cause] The total quantity of error lines detected with G3 exceeded the set value.
[Remedy] Confirm the model of the other machine, and execute the operation again. If receiving,
ask the sender to send again.
[Cause] This machine does not have confidential or relay function. The F-code sent from the
other machine contains an instruction for a function not supported by the machine.
[Remedy] If necessary, check whether the sender entered an invalid F-code.
[Cause] The password was omitted or did not match in fax communication.
[Remedy] No measure is required.
Cause and Remedy