Fuji Xerox ApeosPort-IV C5575 Administration Manual page 635

Setting Item Item Number
Reduce/Enlarge 54
(Reduce/
enlarge mode)
17
(Variable %/
vertical
magnification)
18
(Variable %/
horizontal
magnification)
2 Up mode 21
Output
destination
Tray 5 67
confirmation
Grid lines 22
2 Sided printing 12
Sets the print magnification.
[0] (Default) : Preset %
[1] : Variable %
[2] : Fit to Cut Sheet
[Preset %] is a magnification automatically calculated based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
document to fit in the printable area of the output paper. Therefore, when
the size of the document and the output paper are the same, the ratio will be
100%. Also, if [2 Up] is selected, the document will be reduced to the size at
which two pages fit onto one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/Enlarge]. A
reference point for scaling (reducing/enlarging) is the upper left corner of the
printable area. This reference point applies to all text, images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area onto the printable area of
the output paper. It is a magnification automatically calculated based on
[Original Size] and [Paper Size], and reduces/enlarges the entire document
(including the area outside of the printable area) to fit onto the printable
area of the output paper.
Sets the magnification for the vertical or horizontal direction.
[45 to 210] (Default:100): 45-210%
Note • When a continuous form paper is selected for [Original Size], print result is
identical for [Preset %] and [Fit to Cut Sheet].
Sets whether to print with the 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the other.
[0] (Default) : Off
[1] : Forward
[2] : Reverse
Important • When [Landscape] is selected for [Original Size], print result is identical for
[Forward] and [Reverse].
9 Sets the output tray for the printouts.
[0] (Default) : Right Top Tray
[1] : Left Top Tray (optional)
[80] : Right Middle Tray or Center Tray
Prints from Tray 5, after you instruct to print and then operate the machine
to start printing.
[0] (Default) : Off
[1] : On
Sets the method for printing double-byte grid lines. The options are as
follows.
[0] (Default) : Image
[1] : Font
Sets the 2 sided printing.
[0] (Default) : Off
[1] : Head to Head
[2] : Head to Toe
Important • When [Postcard] is selected for [Paper Size], [Head to Head] and [Head to
Toe] cannot be selected.
ESC/P-K Emulation
Value
16
635