Fuji Xerox ApeosPort-IV C5575 Administration Manual page 95

• Make sure that the following settings are specified under [Tools] > [System Settings] > [Copy Service
Settings] > [Copy Defaults] in the System Administration mode before calibration.
-Lighten/Darken: Normal
-Contrast: Normal
-Sharpness: Normal
-Saturation: Normal
-Color Balance: 0, 0, 0
-Color Shift: Normal
• You can change the above [Copy Defaults] settings after calibration.
• For information on [Copy Defaults], refer to "Copy Defaults" (P.187).
• During calibration, the machine cannot receive print jobs or faxes.
The following describes how to calibrate the machine.
1
Select [Calibration] on the [Services Home]
screen.
When [Calibration] is not displayed, follow the procedure below.
1) Press the <Log In/Out> button.
2) Enter the System Administrator's user ID
with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next]
and enter the System Administrator's
passcode, and select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools] on the [Services Home] screen.
Note • When the [Services Home] screen is not
displayed on the touch screen, press the
<Services Home> button.
Executing Calibration
<Log In/Out> button
3
95