Installation When Using Microsoft Network (Smb); Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox ApeosPort-IV C5575 Administration Manual

Installation When Using Microsoft Network (SMB)

This section describes how to install the machine using Microsoft Network (SMB).
The following shows the reference section for each procedure.

Step 1 Preparations .....................................................................................................................................................................329

Step 2 Configuration on the Machine.....................................................................................................................................329

Step 3 Configuration on the Computer ..................................................................................................................................330
CentreWare Internet Services Setting Items.........................................................................................................................330
Step 1 Preparations
The following items are required to set up the machine to use Microsoft Network (SMB).
NetWare server
TCP/IP or NetBEUI network environment
The Driver CD Kit (provided with the machine)
Step 2 Configuration on the Machine
The following describes the configuration procedures to use Microsoft Networks (SMB) on
the machine. Enable the LPD Port, and then configure TCP/IP settings.
Note
For the items that can be configured using CentreWare Internet Services, refer to "CentreWare Internet Services Setting
Items" (P.330). For information on how to configure the setting using the Driver CD Kit, refer to the manual contained in the
Driver CD Kit.
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
Note
3) Select [Tools].
2
Enable the SMB port.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SMB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
• You can configure the settings using CentreWare Internet Services or the Driver CD Kit.
• The default user ID is "11111".
• The default passcode is "x-admin".

Installation When Using Microsoft Network (SMB)

7
329