Replacing Staple Cartridge (For Finisher-B1) - Fuji Xerox ApeosPort-IV C5575 Administration Manual

3 Maintenance
3
After you take out the staple cartridge, check
inside of the finisher for any remaining staples.
4
Pinch both sides of the empty staple case with
your fingers (1), and remove the staple case
from the cartridge (2).
3
5
Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
6
Push the staple cartridge into the finisher until
it clicks into place.
7
Close the finisher front cover.
Note

Replacing Staple Cartridge (for Finisher-B1)

When the optional Finisher-B1 is installed and the staple cartridge needs to be replaced, a
message appears on the touch screen. When this message appears, load a new staple case
into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance.
Note
76
• If the front cover is not closed completely, a message appears and the machine will remain paused.
Use only staple cartridges recommended by Fuji Xerox.
• To order a staple cartridge, contact our Customer Support Center.