Table of Contents
Advertisement
Chapter 2 Basic Operation
Set the media feeding
Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor printing.
• When you have changed the media type, check the pattern and perform adjustment depending on the status.
• When printing with a take-up device, set the media first and then perform media correction.
Flow of media feeding correction
Perform media feeding correction as below:
Check that the feed correction
1
setting value is "0".
2
Make the torque of the tension
Print the correction pattern.
3
Check the pattern and adjust
4
the counter weight of feeding/
take-up tension bar.
If correction by counter weight
5
adjustment is not enough,
adjust the torque.
If correction by counter weight/
6
torque adjustment is not
enough, input the correction
value in the feed correction
setting.
2-24
Referring to "Setting of Media Correction"
(
P.2-26).
Referring to "Setting the torque limiter"
(
P.2-25).
Referring to "Setting of Media Correction"
(
P.2-26).
Referring to "How to adjust the weight of feeding/
take-up tension-bar" (
Referring to "Setting the torque limiter"
(
P.2-25).
Referring to "Setting of Media Correction"
(
P.2-26).
P.2-18).
Advertisement
Table of Contents
