Set The Media Feeding; Setting Feed Correction - MIMAKI JV400-SUV Series Operation Manual

Set the media feeding

Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor
printing.
• When you have changed the media type, check the pattern and perform adjustment depending on the status.
• When you have changed the temperature of the heaters, make sure that the [CONSTANT] lamp lights
up and that the preset temperature is reached, and then start the correction.
When using a roll medium, rewind the medium by hand before printing so that it is not loose.
•
When the roll medium has not been rewound tightly, it may cause image quality to
deteriorate.
• When printing with a take-up device, set the media first and then perform media correction.

Setting Feed Correction

A pattern for media correction is printed and a media-feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is obtained in the boundary between the two bands.
1
Set a media. (
2
Press the
3
Press the
4
Press the
5
Check the correction pattern and enter a correction
value.
Enter a correction value in "+": The boundary between the two bands is widened.
Enter a correction value in "-": The boundary between the two bands is narrowed.
Entry example: Entry example: When the
patterns overlap
When entering the value in "+"
2-20
Second band
First band
P.2-5)
key in LOCAL.
key.
key to print a correction pattern.
F E ED COMP .
F E ED COMP .
PR I N T
F E ED COMP .
=
When one pattern is away from
0 When entering the value in "-"
Media advance direction
< EN T >
[ EN T ]
* * PR I N T I NG * *
P L E A SE WA I T
0
the other