Chapter 5 Troubleshooting
When media heaves up at feeding
We call the status of heaving media at feeding "cockling".
When media cockling occurs, check the following items:
Note/ checking items
Checking media set status
Adjusting heater temperature
Media feeding
Do not leave the media in the heater warming
status
Heighten the head
5-6
Measures
(1) Check that the media is set straight and reset it.
(1) Upper pre-heaters' temperatures.
(1) For roll media, feed the media by about tens of centimeters to one
meter.
(2) For leaf media, press [][] and perform feed/ back feed.
(1) Do not start printing with the media cockled because it may cause
media jam.
(1) For the thick media, make the head gap higher before printing.