Set the media feeding
Correct the feeding rate of media.
If the correction value is not appropriate, stripes may appear on the printed image, thus resulting in a poor
printing.
• When you have changed the media type, check the pattern and perform adjustment depending on the
status.
• If the heater temperature is changed, start the correction after confirmed by checking the temperature
panel of heater that the temperature has reached the set temperature.
• When printing with a take-up device, set the media first and then perform media correction.
• If the adsorption fan is used, start the media correction after turning on the adsorption fan.
Setting Feed Correction
A pattern for media correction is printed and a media-feeding rate is corrected.
• Two bands are printed in the correction pattern.
• Make adjustment so that an even color density is obtained in the boundary between the two bands.
1
Set a media. (
2
Press the
3
Press the
4
Press the
5
Check the correction pattern and enter a correction
value.
Enter a correction value in "+": The boundary between the two bands is widened.
Enter a correction value in "-": The boundary between the two bands is narrowed.
2-26
Second band
First band
P.2-5)
key in LOCAL.
key.
key to print a correction pattern.
Media advance direction
F E ED COMP .
< EN T >
F E ED COMP .
PR I N T
[ EN T ]
* * PR I N T I NG * *
P L E A SE WA I T
F E ED COMP .
=
0