Honda 2002 Accord Manual page 170

Cylinder Head
Timing Belt and Balancer Belt Installation (cont'd)
19. Align the rear balancer shaft pulley with a 6 x 100
mm bolt (or equivalent).
-1 Remove the bolt (A) and washer (B) from the
maintenance hole (C).
- 2 Scribe a line on a 6 x 100 mm bolt, 74 mm (2.9
in) from the end.
- 3 Insert the bolt in the maintenance hole and into
the hole in the balancer shaft (D) up to the line
you scribed.
20. Align the groove (A) on the front balancer shaft
with the pointer (B) on the oil pump housing as
shown.
21. Install the balancer belt. Loosen the adjusting nut
2 / 3 - 1 turn to tension the balancer belt. Retighten
the bolt.
22. Remove the 6 x 100 mm bolt from the maintenance
hole and reinstall the sealing bolt. Tighten the bolt
to 29 N m (3.0 kgf-m, 22 Ib-ft).
23. Adjust the balancer belt.
-1 Temporarily reinstall the crankshaft pulley.
- 2 Loosen the adjusting nut 2 / 3 - 1 turn.
- 3 Turn the crankshaft pulley 1 turn
counterclockwise, then tighten the adjusting
nut.
24. Remove the 6 mm bolt from the timing bolt
adjuster arm.
25. Check the lower cover rubber seal for cracks and
other damage.
NOTE:
• If the seal is coming off, reattach it with liquid
gasket. Wipe off any excess liquid gasket.
• When replacing the seal, clean out the groove in
the cover, cut the repair strip to length, and press
the new piece into the groove.
26. Remove the crankshaft pulley and reinstall the
lower cover.
27. Install the rubber seal around the adjusting nut.
28. Clean the crankshaft pulley bolt and washer.
29. Clean all oil off the inside face (A) of the crankshaft
pulley, and apply lubricant to the pulley bolt (B) and
washer (C).
O: C l e a n
# : L u b r i c a t e
6-28