Testing A Preset Tour On A Rapiddome Camera; Figure 6-13 Location Of The Program Vector Button - Honeywell Rapid Eye Administrator's Manual

Pan, Tilt, and Zoom (PTZ) Setup

Testing a Preset Tour on a RapidDome Camera

108
8. Repeat step 7 above, as needed. While adding more presets, you also have the
option of using the following commands:
• Move Up/Down. You have the option of moving a preset up or down the list, and
keeping its Speed and Dwell times. Right-click in the # column cell that is on the
line of the preset. A menu appears. Click Move Up or Move Down, as needed.
• Delete. You have the option of deleting one preset or many from the list.
Right-click in the # column cell that is on the line of the preset. Click Delete on
the menu that appears. To select many presets, press and hold
selecting different lines in the # column.
• Test. You have the option of testing the preset tour by clicking Test. Click End to
stop testing a preset tour.
• Rename tour. You have the option of renaming the preset tour. Click inside the
box next to Preset Tour (Vector). Enter a name. In
replaced the default name of Vector 1.
9. Click Program Vector to send the tour of presets to the camera. To program another
tour of presets for the dome camera, repeat
Figure 6-13 Location of the Program Vector Button
1. While using View, select the site at which you have programmed a Preset Tour on a
RapidDome camera, as shown in procedure
RapidDome Camera.
2. Run a Maintenance Session
programmed with a Preset Tour.
3. Click PTZ. Check if the Driver is RapidDome/Orbiter. If not, the wrong camera or site
may have been selected in
be used.
4. In the Tour Programming section, select Preset Tour (Vector).
5. Select the preset tour that you plan to test. To do so, click the drop-down arrow above
Dwell Time and select a tour from the list that appears (by default, the list shows
Vector 1, Vector 2, Vector 3, and so on). Click Test.
step 6 to
Setting Up a Tour of Presets on a
and click the Video tab. Select the dome camera that is
step 1 and the remaining steps in this procedure cannot
Ctrl
while
6-13, Entrances has
Figure
step 7, as needed.