Table of Contents
Advertisement
Configuring the Users
Document 800-06847 Rev B
08/10
4.
Select the firmware from the firmware list, then click UPGRADE.
The firmware upgrade begins.
FACTORY DEFAULT
SYSTEM DATA
PASSWORD
Configuring for Controlling DVRs
You can configure your system to control up to 254 DVRs from the same keyboard.
1.
Click CONTROL DEVICE on the left side of the SYSTEM window.
The CONTROL DEVICE menu appears.
Figure 2-42
CONTROL DEVICE Menu
2.
Use the
to configure the following settings:
SYSTEM ID
If more than one DVR is connected on the same RS485 bus, each
one must have a unique ID.
Note
PROTOCOL
Must be set by Control Device.
BAUD RATE
Must be set to match the baud rate of the PTZ controller.
Select USER in the Main system setup window, then click
opens.
HREP Color Digital Video Recorder User Guide
Use to restore factory default settings.
System settings can be saved to a USB memory stick. The
settings can be reloaded in case of accidental factory
default or can be transferred to another DVR if multiple
units need to be installed with the same settings. All
information is saved apart from the network settings and
the system name.
Activates/deactivates the need for a password to enter
specific menus
If you are using more than one DVR on a stack, then each
DVR must have a unique ID for being controlled by a
remote control.
. The USER setup window
51
Advertisement
Table of Contents
