Setting Up Motion Detection Recording - Honeywell HRDP DVR User Manual

Setup

Setting Up Motion Detection Recording

______________________________________________________________________________________________
46
To record data only when motion is detected:
MOTION/EVENT CONFIGUR ATION
CH
1
2
3
4
5
6
7
8
9CH-16CH
INPUT
1. Press Setup on the front of the DVR or remote control.
2. Select Record > Motion/Event Configuration and set MOTION to On.
Set SENS level. [Normal / High / Highest / Low].
3.
Select AREA and press ENTER to set a motion area (global setting;
4.
each channel can be configured individually).
Use the arrow buttons and the numeric buttons 1, 2 and 3 to navigate
5.
the motion area grid. (Selected motion areas are highlighted green on
the grid.)
1 = Set Mode
Press 3 on the front of the DVR or remote control.
a.
b. Use the arrow buttons to move the cursor to the desired location on
the screen.
c. Press 1 on the front of the DVR or remote control.
d. Use the arrow buttons to highlight the desired motion detection area.
Repeat the steps above to create additional motion detection areas.
e.
When finished selecting motion areas press ENTER on the front of the
6.
DVR or remote control to save changes.
Repeat as necessary for each channel.
7.
When motion area setup is complete select SAVE to save settings and
8.
exit setup.
MOTION SENS AREA SENSOR
ON NORMAL
ON NORMAL
ON NORMAL
ON NORMAL
ON NORMAL
ON NORMAL
ON NORMAL
ON NORMAL
SENSOR ACTION
SAVE CANCEL
2 = Clear Mode
INPUT
V-LOSS
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
ALARM MONITOR
3 = Move Mode