Parallel Port; Floppy Disk Controller; Base I/O Address; Dmi Event Logging - Silicon Graphics Altix XE250 User Manual

Parallel Port

Floppy Disk Controller

Base I/O Address

DMI Event Logging

Event Log Validity

Event Log Capacity

View DMI Event Log

Event Logging

ECC Event Logging

007-5467-001
This setting allows you to assign control of the parallel port. The options are Enabled (user
defined), Disabled and Auto (BIOS-or OS- controlled).
This setting allows you to assign control of the floppy disk controller. The options are Enabled
(user defined), Disabled, and Auto (BIOS and OS controlled).
This setting enables you to select the base I/O address for the Floppy port. The options are Primary
and Secondary.
Access the submenu to make changes to the following settings.
This is a display to inform you of the event log validity. It is not a setting.
This is a display to inform you of the event log capacity. It is not a setting.
Highlight this item and press <Enter> to view the contents of the event log.
This setting enables you to Enable or Disable event logging.
This setting enables you to Enable or Disable ECC event logging.
Advanced Setup
5-135