Compact Flash Master/Slave Select (JCF1)
A Compact Flash Master (Primary)/Slave (Secondary) Select Jumper is located at JCF1. Close this
jumper to enable Compact Flash Card. Connect the Compact Flash Card power cable to JWF1 so the
Compact Flash Card works properly (refer to
Compact Flash Power (JWF1)
A Compact Flash Card Power Connector is located at JWF1. Connect a Compact Flash Card power
cable to JWF1 so that the Compact Flash Card to works properly, and enable it with JCF1 (refer to
Figure
3-30).
007-5467-001
Table 3-37
Compact Flash Master/Slave Jumper Settings (JCF1)
Notes
Figure
3-30).
Table 3-38
Compact Flash Jumper Settings (JWF1)
Notes
JWD
Figure 3-30
Compact Flash Jumper Settings (JWF1)
SATA0-SATA5
5
0
JBT1
Battery
T-SGPIO-2
J7
T-SGPIO-1
JPG1
JWF1
JCF1
Node Board Jumper Settings
JCF1 Jumper Settings
JCF1
Jumper
Definition
Open
Slave (Secondary)
Closed
Master (Primary)
JWF1 Jumper Settings
JWF1
Jumper
Definition
On
Compact Flash Power On
Off
Compact Flash Power Off
IDE 1
3-81