Power Supply - Compaq ProLiant 1600 Maintenance And Service Manual

Power Supply

To remove the power supply:
1. Perform the preparation procedures. See page 2-2.
2. Remove the left side access panel. See page 2-9.
3. Remove the processor cage. See page 2-22.
4. Slide the hot-pluggable drive cage out slightly 1. See Figure 2-8 to determine which
screws should be removed.
5. Remove the air baffle by detaching the hook-and-loop fastener holding it to the power
supply.
6. Disconnect the power supply cable from the power switch. See Figure 2-17 on page 2-
20.
7. Disconnect all other power supply cables.
8. Remove four T-15 screws securing the power supply to the back of the chassis 2.
9. Pull the power supply out the side of the chassis 3.
2
Figure 2-25. Removing the power supply
Reverse steps 1 through 9 to replace the power supply.
3
Compaq ProLiant 1600 Servers Maintenance and Service Guide
2-29
1