Compaq ProLiant 1600 Maintenance And Service Manual page 117

3-72 Diagnostic Tools
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Pager Data
Dial-out status
Dial-out string
Network status
Network
protocol
Network
controller
Network host
name
Network card
slot
Network frame
type
Continued
Setting
Enabled Allows ASR-2 to dial out to a remote workstation. If you selected
this option, Dial In Status is automatically selected.
To use the dial-out feature, set Dial-Out Status to Enabled and set
the Dial-Out String to the correct phone number. You must also set
the Reset Boot option to Boot Compaq Utilities. When the system
restarts because of an ASR reset, the administrator is paged via
Pager Status and Pager Dial String, the system restarts to the
Compaq Utilities, and dials out to the phone number provided in the
Dial-Out string. The dial-out number will be tried five times. If it fails
to connect after five attempts, the modem is put in auto-answer
mode.
555-1234 Enter the dial string followed by the remote computer telephone
number.
Enabled To allow network access to Compaq Utilities, set Network Status to
Enabled and make sure the Reset Boot option is set to Boot
Compaq Utilities.
To use IPX network access, set Network Protocol to IPX. When the
system restarts to the Compaq Utilities because of an ASR reset, it
loads IPX network support. This enables remote access via NVT.
To use IP network access, set Network protocol to IP. Also make
sure to set Network IP address, Network IP net mask, and Network
IP router address. When the system restarts to the Compaq Utilities
because of an ASR reset, it loads IP network support. This enables
remote access via Telnet.
NOTE: The Network Status must be set to Enabled for network
access.
Compaq For all Compaq Standard Network Controllers.
CPQHOU Enter the network name of the server. Use underscores instead of
spaces within the name, for example, Compaq_Server. If you are
using IPX network access to the Compaq Utilities, this server name
is used to advertise NVT host services. This server name displays
in the Compaq Insight Manager server list when it determines it can
communicate via NVT. Set this name to be the same as the server
name you assign when the host OS is running.
Slot # Select the slot number of the network interface card you wish to use
for network access to Compaq Utilities.
ETHERNE Select the frame type for your network. Selections include both
T_I I Ethernet and Token Ring topologies.
Description
Continued